Recent content by bcchevy

Some fun this weekend

Just by hand there was a very noticeable difference Changed tstat today and right back at the correct needle position on the dash Computer reading 209-215 with ac on in moderate traffic

As promised..just a little late Hole in the side Back in running great but temp is a little high Lower hose is a little cooler then the upper so leaning towards a bad t-stat Luckily I have a whole engine with many new delco parts on it for a cheap and easy swap over to the current engine

Motor is at work Grab some tomorrow

To update I installed the engine Was a bear to wrestle in there Everything going good Will be swapping more parts over soon as well W/p f/c thermostat vvt sensor and alt

Disconnect was rebuild and awd sleeve installed. Gonna ck the ratio tomorrow didn't get it in tonight. If it's a 3.73 I may look for a 3:73 rear with a posi Will keep it updated What do you guys think about running 44k oil flush Will also be swapping thermostat alt and vvt solenoid Don't like...

Carnidge pics to come

Hole in number 3 cylinder wall I think maybe #2 Anyway this 78000 mile replacement going in tonight Knew it was gonna go but had to get to work so I drove it Still runs but oil blowing on exhaust did not make the local authorities happy Drove 2 miles at 75 just to see what would happen Well...

Fan clutch

Thanks for the gear! Bcchevy

To bad you weren't a little closer! I've got the gauge and whatever else you would need Def sounds like fuel.. bad ground or connection Ck all your battery cables as well Had some rust build up and didn't have a great ground all the time. Good luck moots

Real easy to make them!

Here's mine With my other toys

Was it a torx or allen? Not so much for me as I have both and can look and see but noobs may not get a clear answer.

I made a set of brackets Real easy just need a welder for mine Not sure if others were bolt on I would direct a link just not sure how. Bcchevys build Good luck!