Recent content by benjaminblazer

So i ended up getting it just to try it out because it was 1 day shipping and they wouldnt respond to my email. Anyway, unfortunately recalibration is not supported on my vehicle, but I did read up on a couple of the code that they listed, including my p0171 issue. They state that the mixture...

The first install i did not know this because no instructions were given on the video or the product. The second install i just did it was as straight as I could get it but obv wasnt perfect so was that the issue?

Wow, so 200 just to reprogram a stupid steering angle sensor that wasnt even necessary to replace, I hate this vehicle😂 You think a shop would charge around the same price?

How hard is that to do, finally got the time to put a new one in, pulled the pin after full installation and still showing up as soon as I turn the wheel

While I have yet to try anything yet because of the massive snow storm, I have done some research about the installation of the sensor. Apparently you arent allowed to move the wheel at all when installing same with the sensor itself and I remember taking out that pin before install because no...

I know this thread is super old but I finally got the time to replace the steering wheel position sensor... well after doing so, the traction control and repair light come on every single time I turn the car on, almost like I either got a bad one out of the box, or wiring on it went after I...

Do 2006s have MAP sensors or just MAF

Sounds good, and I do hear a small exhaust leak, like a trickling when I start the car not sure if thats the on manifold or not though.. can try and look for it tmr though

What would this do though..? If i already replaced with a new

Did not try the checks with the relay yet. I am the second owner and it has 165k That was around a day after tightening.

good info, thank you and alright I'm going to try the carb cleaner method, outside, extinguisher in hand. Is there anywhere specific that i should spray, heard a lot of people say close to the fire wall. Or just what the video presents. Also thinking about buying a smoke generator and doing that...

Alright so after a short day of swapping the solenoid and unfortunately not the pump here is what I have found. I have a picture of the old solenoid, the hose and connection, scraped the old gasket off and of course added the new one on. Had a couple questions about the other pictures as well...

I see, dont they make a relay tester too, where you just plug it in

I used the process you sent me, the thread.. where you pull the fuse and listen. Im just going off of what you sent me. And I tested the relay with a multimeter, testing ohms looking for the common 50-200 range. I also checked a relay that I knew worked and got the same resistance. And correct...

So checked the sol fuse and relay both fine. Bought a new Solenoid and pump, will both be here Wednesday. Figured id put in new parts anyway, I know just throwing parts at it isnt the best idea but I do not have a bi directional scan tool and id rather have the parts be on the way because I only...