Recent content by JB100

$44.99 plus shipping. Look under truck then chevrolet trailblazer SS this is for a 3 pod one.

A HUGE BFH and a can of PB Blaster will work wonders on most bolts and stuck things! :smile:

Possible bad CV shaft? My Kia had a bad vibration at 60+ MPH. Turns out it was bad CV shafts. Now its smooth as silk on the highway. Just a thought.

This is inline as the idiots who took a brand new ZL1 Camaro and decided to destroy the paint job to make a "rat rod" out of it. Poor car.

I had to change both of mine last summer. One is an O'reilly and the other is an Autozone house brand. I have since put about 40K miles on them with no problems. Both of them were replaced in 100+F heat.. Who knew that Vegas was 95+ F at 6 am in the morning? I reused the original ABS...

Welcome to the forum from a former Keene resident.

Darn those pesky details.

Since you don't mind that the OnStar is not used here is a link to the correct adapter Car Radio Stereo Wire Harness Install Interface Axxess LC GMRC 01 | eBay

Goto www.blazerforum.com there is a wealth of info there on the S Series trucks.

Mooseman has a good point. My 96 would run out of gas at 1/4 tank. I learned that one the hard way. Once I replaced the fuel pump/sending unit assembly it worked great.

I was looking at this thread again something jumped out at me.. You said they replaced the fuel pump. If they put an Airtex or one of the cheap junk pumps in it it will not last long. I had one in my 96 that went bad. It was an airtex pump and the fuel gage never worked properly. I replaced...

On the 97, it sounds like there is no injector pulse. The 97 has an fuel injection "spider" under the upper intake plenum. You can check the inj pulse at the connector. If memory serves it requires about 50 LBS of fuel pressure. There is a pressure test port on the back of the intake where...

I am putting back on the road a 2000 Kia Sephia to use in my job. I had some questions about fluids as this car has been mistreated badly by its former drivers. It needs a bit of work to get it up and running. Anyway, I wanted to know what type of trans fluid it wanted. Because it looks like...

I learn something new every day. I'll take your word for it.

I was under the impression that all TB's have the OLM. I know mine does. A nifty little oilcan with a wrech symbol next to it.