Recent content by Kuchar09

Yup just had to cut off the old flange and clamp the new one on.

Well I'v had my header on for about 3 weeks now and have to say I'm happy with how it turned out! I did notice my engine light came on after 50 miles and gave me the code P1133. The engine light then shutoff after 200 miles but the code still shows up in torque so not sure why the light isn't...

Well I'm working on getting my header on and once I got the heat shield off I found out that my header isn't cracked but instead the farthest back 3 bolts were broken off. The farthest one broke off in the head and the other 2 at the head so I could get them out with vice grips. I'm working on...

Wasn't sure if I should make a new thread or not but figured I'd just throw it in here. I'm having a little problem with my amp going into protection mode when I turn the volume past half way. This just started last week and has been fine since the install a few months ago so not really sure...

Since I have an 06 am I going to run into any problems installing these that I should be contacting Kook's soon about? I have another 3 weeks before I get home and can install them so I haven't seen them besides pictures.

I received mine from the group buy for an 06 so it shouldn't be too much longer.

Just received a call from my parents and the header was delivered today! Too bad I won't be home for another 6 weeks due to school. :frown:

Finally messed with my backup cam and have it automatically opening when in reverse and closing when put in park or drive. Since I had an issue with just seeing a white screen someone recommended I put polarized sunglasses up to the camera and see if it made a difference, which it did. So I did...

How do u plan on doing audio? if your going to do it over bluetooth or the 3.5mm headphone jack I would take a look at getting a dock to put in there then you don't have to try and mess with the usb plug when you want to remove it. Of course with out the usb plug you can't do a joycon, usb dac...

Yeah I know I'm going to school for electrical engineering, but you'd be surprised how often a good smack will fix computer/electronics. I was hopping there would be some kind of stuck relay or something but instead I found a burnt chip. I found a thread where you said that they changed the...

Well the blower wouldn't turn off so I did a little looking online and figured the blower motor control module might be stuck so I unplugged it and the blowing stopped lightly tapped it with a hammer and plugged it back in. Now the blower don't turn on at all. Pulled the HVACB fuse and looked at...

Amazon... link is in the first post.

Used the joycon EXR with the C channel taped into the reverse wire that was on my aftermarket wiring harness. I then ran a usb extension from my hub to the back hatch for the camera. Then all I had to do was program the key press (reverse signal) to launch the special app to use a webcam. I...

I actually got the steering wheel controls working no problems. I had slight issues with my backup/ webcam since I cut the wires and extended them, but finally got that working now and should have it installed next week possibly. I like the idea of the roaming access point in case you don't...

16 or 18 gauge should be fine. Be sure to label all your wires as you go.