Recent content by prken

and also like I say the truck is running strong, better than ever

I did it on jack stand the process than run for 6 to 8 minutes at 55 down to 45 for 2 min and so on

After replacing all the sensor mention above I havent reset or diconect the battery I just want to pass inspection

Just replace cam sensor,crank solenoid and cam position. To clear the code 1445 now no codes after 150 miles. Try to get the truck inspected but the computet said that the Catalyst Mon and the Eval System Mon there are inconpleat. Do I have to take it to the dealer to do a relearn. The truck is...

the cleaning was done with an air compressor hook up to a air fitting with a hose spraying with gas

I can't remember if he clean it with or without, but after that code came on I disconnect the cam position, the crank position, and the solenoid, all 3 of them, the 2 in the front and the one under by the oil pan I guess

I will check it out tomorrow to make sure they are seated correctly, question do you know if I have to do a CASE Realearn now

Hello there, A friend of mine was cleaning the engine on my 02 TB, he disconect the ECM to clean it out and now the truck is all mess up is idling very rough, and giving me a p1345 code

yes that is the one that I will be replacing alone with the other 2 sensors, the Crankshaft Position and the Camshaft Position Sensor, to see if the code 1345 will go off

yes that is the one that I will be replacing alone with the other 2 sensors, the Crankshaft Position and the Camshaft Position Sensor, to see if the code 1345 will go off

Hey I got a question, do you did a relearn procedure after replacing all that, I have the same codes on my 02 trailblazer

I think the brand was STANDAD but I return it today, I clean the CPAS but on tuesday I will replace all 3, the 2 in the front and the one by the transmission on the side to see what happened, also can I do the relearn process with the truck in jack stands and do the 55mph and then the 45 and all...

yes, I told him that I put new spark plugs and he ask me if I re-gap the or if I check the gap, I told him that they already are but he check and I think he re-gap them

thanks for remind me I was a member here before but I forgot about it

Hello, need a little help here, I just did a valve cover gasket change, what a pain but finally done, after that code 1345 came on, change the cam sensor, and clean the crank sensor, the one with the 3 screens I guess that how you call it, and also clean the throttle body. last month put new...