Recent content by Upsman

Good aft. Would anyone have the value for the shunt resistors for the shock connectors for the delete? The truck is spread all over the floor waiting for me to get going, had to stop in the fall and I am recuperating from hernia surgery. I contacted the mto regarding the safety and they did...

wow thank you sir leaving for the shop soon.i have observed you try to help all with your considerable knowledge I am honored thank you larry

2007 escalade getting ready for safety Ok in the hope that someone else has seen this, unit on jackstands in the garage. Unable to open liftgate. Opened it after much despair flicking the liftgate latch. So on remote taillights blink once but no sound from actuator. Fuse 44 underhood is good...

Thanks my friend. Tailgate was working now it blinks the taillights but no noise from tailgate. Thank you for the link

I'm doing the same thing on Escalade to prepare it for a safety check because excessive rust is a problem I repaired a couple of areas up over top of the spare tire which it brought it away I put a new steel panel in secured it undercoated it and I'm going to be covering it with a slits gun with...

Good morning guys this is voice to text so I apologize for any years I have a 2007 Escalade and I'm wondering is there a link in here for the service manual for that year of trucks I'm looking for some wiring diagrams as I'm trying to prepare for safety check and I'm running into a few problems...

Sorry I did voice to text what's that

Good afternoon guys I had an 03 Escalade but the rust and the ongoing problems anyway we've retired it for the moment mooseman helped me get it going anyway we now purchase the 2007 Escalade and I'm trying to get it ready because in Ontario we have to have a safety check but of course January we...

Afternoon all, just to announce we have acquired a 2007 Escalade, 6.2l. The 2003 is parked and as am laid off, I am working to fix it up for an Ontario safety. 2003 has more electrical issues and blown brake at an multiple block, all rusted to he'll anyways that's what I am doing today!

So after I replaced the tranny cooler with new, more atf, fired it up, no leaks, backed off the ramps, went down the driveway 4-5 times, no probs, ok, backup to the garage and there goes the brake pedal to the floor, crap, blew a brake line at the combo block under the drivers area. So...

Ok I may have found something, according to some sites I have seen, the 6.2 Escalade has several grounds on the ECM, 6 on the C1, at least 2 on C2. Pinouts If I ohm between several of them, open circuit. So following the harness, up the engine and on top of the intake at the back near the...

Your efforts, your fuel but I would not have found you and the forums help without this community. Thanks all for the comments and advice. MasterBlaster sets the tone!

So the Master is correct, he found the issue and while it only ran a few minutes and puked up a transmission cooler, we are greatly relieved that it has come back to life. Yes I will work on the other issues later. Unfortunately I ran out of time as one my Alpcas went into distress and we had to...

https://gmtnation.com/forums/members/mooseman.6163/ Any chance you could rop me an email? Thks Larry

Radio removed, did not remove cd changer, but the result remains the same. No more time today, pretty discouraged. I did tell you it has a bypass module for the remote starter, it has an led on so hopefully that is not acting up, but that is where it is at.