Recent content by Alfa-Norway

Maybe you can try this. Disconnect the HVAC control module Clear all DTCs. Place the ignition switch to the OFF position. Install the HVAC actuator. Connect all previously disconnected components. Remove the HVAC/ECAS fuse for a minimum of 10 seconds. Install the HVAC/ECAS fuse. Start the...

Windows XP Professional 32-bit Edition SP3 VOL M6TF9-8XQ2M-YQK9F-7TBB2-XGG88 SP3 VOL MRX3F-47B9T-2487J-KWKMF-RPWBY SP3 VOL QC986-27D34-6M3TY-JJXP9-TBGMD SP3 VLK TQMCY-42MBK-3R4YG-478KD-7FY3M

I get an Electronic Brake Control Module (EBCM) in that does not work properly from a friend. Have understood that there may be poor solder points that may be the cause. Where are the solder points that are most likely bad? Is there any way to test drive it on the bench before I send it back ?

Yes

They are genius the delivery people, no brain no pain:Banghead:

No it was broken inside too. When I spun it, it was slow and made a bad sound. I sent it back and got a new one.

If DTC B0077 is current, disconnect the left SIS connector. If DTC B0078 is current, disconnect the right SIS connector. Refer to Inflatable Restraint Side Impact Sensor Replacement . Inspect both the SIS and harness connector terminals for damage or corrosion.

I ordered an alternator from RockAuto with shipping by Fedex. It came completely destroyed. Next time I will use DHL which is much faster but a bit more expensive.

Here are pinouts

Maybe this one help you. From 2004 GMC Truck Envoy - 4WD

Some gm ipc especially 03-04 mod eeprom ( U15 ) sits close to the prnd321 display and are difficult to mount chip holder clips. at 05 and up eeprom has changed places. I have seen someone who bends away the display a little too get the clip mounted but it is not recommended. You must not...

Update on Eeprom programmer. I had 4 extra pcb`s and bought 4 Arduino nano`s from china that would not read eeprom. Led bulbs, there are (4 pcs) of them, Led no. 4 marked l stood and flashed. Had to use old bootloader then it worked. For information only.

I get led from GM Gauge Repair Onalaska Wisconsin | eBay Stores

Its always good to see new thing come to live.

I do not remember exactly how I did it, but had to try several times before I found the right setting. When you have found the correct setting, you must press the button so that the character is in the top position. then you can turn the knob so that you increase the hz from 0 and up. Hope that...