Recent content by Drec

  1. Drec

    All dash lights on

    Ordered a new ignition switch today. Received the Hantek today. The switch will be here by weekend, so it will be a while before I can get into this, I'll report back.
  2. Drec

    All dash lights on

    No, but I'll look at it.
  3. Drec

    All dash lights on

    Update: I ordered a Hantek 1008C yesterday and I'll be here tomorrow. Picked up a Dell Lap Top today and hopefully I'll be able to spend some time (hours/days) trying to learn how to use it. There appears to lots of videos on learning the Hantek. After doing to module reset I drove the Envoy on...
  4. Drec

    All dash lights on

    Looking around for the last couple of days for an answer, without any luck. Went out today and the same thing happened. Shut off the car and then had no instruments or radio. Got back home and did a body control module reset, now I have instruments and radio. I’ll just have to wait and see what...
  5. Drec

    All dash lights on

    Did you solve this problem? I'm experiencing the a similar situation. Several weeks ago, the dash lights started coming on and then flashing. They did that off and on for about a week, then the radio switched off. The radio is a replacement (Kenwood), that I installed about a year ago. Since...
  6. Drec

    2002 Envoy Transmission leak

    The transmission shop hadn't seen anything like it either.
  7. Drec

    2002 Envoy Transmission leak

    Three weeks ago, I was on a trip (about 120 miles away) and discovered my transmission was leaking ATF. Stopped by an O'Reillys store and bought a gallon of fluid. It was down a couple of quarts, then I filled it up and drove about twenty miles and checked it again, and it was down again. So I...
  8. Drec

    NEED HELP Looking for info on testing COP, good ohm range

    2002 Envoy 4200 running badly. So I changed out the plugs and replaced three COP's. It is now running good. My question is, I checked the ohms reading on all 6 existing COP's; which ran from 10 ohms to 196 ohms. The new COP's ran between 16-35 ohms. I looked for a chart, and haven't found...
  9. Drec

    eBay Listing Ebay searches

    Has anyone noticed that Ebay searches now need a vehicle selected for a parts search. I've had searches saved for years without a vehicle specified. I was looking for a Chevy clutch fork, and tried to save the search. Ebay wanted a specific vehicle noted and wouldn't save the search. Trying to...
  10. Drec

    NEED HELP Shifter locked in neutral

    The Dorman kit that I picked up had 4 bushings in it, two orange and two clear. The directions said to use the clear; which wouldn’t work. I spent about 45 minutes trying. Then I tried the orange bushing; which wasn’t easier, but using some creativity, I was able to get one of them pressed in...
  11. Drec

    NEED HELP Shifter locked in neutral

    I picked up what I thought was the correct bushing; which was a Dorman 14057. While installing it, it seemed like following directions wasn't going to give a satisfactory fix. The directions said to use the clear bushings, that I couldn't get installed. So I used the orange bushings; which the...
  12. Drec

    NEED HELP Shifter locked in neutral

    It cooled down to 98 degrees tonight, so crawled under to take a look. It’s only going to be 100 degrees tomorrow. So after looking at the shift linkage, it’s a bushing problem, so I’ll pick a new one up tomorrow and install it. Thanks to everyone that answered my request for help. I’m not...
  13. Drec

    NEED HELP Shifter locked in neutral

    I’ve been in hiding because of the heat. I did go out this morning and moved the Envoy, with the tractor, so it wasn’t blocking the driveway. I should be able to get it in the air by tomorrow and try to figure out what is going on. It seems like everything comes in bunches. My daughters Saab...
  14. Drec

    NEED HELP Shifter locked in neutral

    The PRND321 is showing R; which now leads me to believe the the cable is the problem. The car is in neutral and will roll.
  15. Drec

    NEED HELP Shifter locked in neutral

    I’m sorta waiting for cooler weather, so I’ll probably start by trying to unlock the shifter by checking out the Park Lock Solenoid. BTW, it’s supposed to be 107 degrees here tomorrow. Then by Tuesday down to 87 degrees.

Forum Statistics

Threads
24,243
Posts
648,347
Members
20,679
Latest member
jer11

Members Online