NEED HELP Looking for info on testing COP, good ohm range

[Drec]

2002 Envoy 4200 running badly. So I changed out the plugs and replaced three COP's. It is now running good.

My question is, I checked the ohms reading on all 6 existing COP's; which ran from 10 ohms to 196 ohms. The new COP's ran between 16-35 ohms. I looked for a chart, and haven't found anything. I would imagine that the COP with the 196 ohm reading, might be out of range, but I don't know.

 

[TJBaker57]

2002 Envoy 4200 running badly. So I changed out the plugs and replaced three COP's. It is now running good.

My question is, I checked the ohms reading on all 6 existing COP's; which ran from 10 ohms to 196 ohms. The new COP's ran between 16-35 ohms. I looked for a chart, and haven't found anything. I would imagine that the COP with the 196 ohm reading, might be out of range, but I don't know.

A few years ago I tested some used coils I had. Details seen here...

SOLVED! - Fuse 28 PCM-1 blows randomly

Engine stops and won't even turn over when it happens. Replace fuse,, starts right up and runs no troubles. I've got 60 miles on since it happened no troubles. 5 years ago I had a similar problem and it was never figured out 100% but was told it may be a bad coil so put all new OEM Delphi...

gmtnation.com