Recent content by dwzook

Thanks for the replies. I am able to shift into all gears, just freely without pushing the button. The nubs that are suppose to lock into the channels aren't coming back up. I will lubricate down the shaft to see if the plastic is bound up somewhere. I tried grabbing the plastic inner shaft with...

Hello all, I bought my 2002 Envoy in early 2013. I have always had a problem where I had to wait for the shifter to "click" after put in park and shut off, before I could removed the key. It was usually only a few seconds, or I could get it to "click" by shifting back out of park then back into...

I went ahead and ordered both mounts yesterday. And got the GM mounts. Do I need to even worry about the tranny mount?

Mine reads 18mpg all the time.

I've had a couple coil packs go out over the last few months. Does your engine code say a specific cylinder misfire? Mine would show random misfire until I drove it for a while so it could figure out which cylinder it was

So I've been noticing the last couple months that I have rough idle with AC on and in gear. And today the drive just feels different. I noticed on a 70mile commute home that at points it felt rough even in cruise like the car would have little jerks. (Not left or right jerks). And got home, shut...

They look intact. No obvious signs of wear.

I guess I should add, the end links all got changed about a year ago with no problems prior to lift. Made sure I tightenened all the end links as well.

Yes I know there are plenty of end link threads. Just another question though. Just got done with my rough country lift. Went driving around, and noticed some squeaking over some bumps. Further inspection I can feel the squeek on the sway bar when moving the truck up and down. Can hear the...

Yes, I got the yellow/blue bilstein 4600 series on the front.

Am I going to run into any problems running the OEM billsteins in the front?

Well I guess good thing they were out of stock! Lol. I thought OEM was ok with just the 2" leveling kit? But thanks for the advice roadie, I'll look into those.

So I am finishing installing the rough country 2" leveling kit. Put bilstein struts on the front. But I just got another notifition that the rear bilsteins are out of stock. All the part stores here say they're not available. And this is the second online store that said they're available and...

Who's had p0300 and what was the problem, or how did you diagnose further? I read a service bulletin stating the injectors have problems.

Tried it again later. Same problem came back with the ac not effecting anything. Drove around the block and got the horrible flashing service engine light with a p0300 code. -_-