Recent content by Ric_Whit

Very interesting video, I wish to have those tools.

Hey Joe_67 I will try with the scan tool, hope I can recreate the P1221 code.

#Mooseman, well I said engine temp because I can feel the temp in the engine bay climb a bit. The fan clutch was replace January 28, 2022 with ACDelco 15-40133. I did the test and the fan clutch past. Pedal sensor I did not replace, I only replace the Throttle Body with ACDelco GM Original...

Hi everyone on this form. I have a 2002 Chevy Trailblazer 2WD 4.2L and occasionally I’m getting CEL P1221 with Reduced Power Mode specially when I driving slowly. When this happen I got my code reader (Innova 5610) cleared the codes and started it back up the engine don’t want to start and the...

What's-up guys, Well guys next month will be 4 years I did this mod. And I can report that till today Sept 7, 2021 I still have the same vehicle and with NO issue, problem or leak. Still going strong. (Knock on wood)

@djthumper I don't want to go that rout. @Sparky I feel the back of the TBlazer is moving side to side when driving

Hi all, I’m about to replace the rear upper and lower control arm of my 2002 Trailblazer LT 2WD 4.2L. The problem is the panhard bar (Parts # 15069843 for 2002-2004 & Parts # 15223490 for 2005-UP 4.2L, 5.3L Eng.) are discontinue. Now here is my question to any one on here that may have done it...

@MRRSM Very good picture that will illustrated where to insert the socket to secure the crankshaft

Hi all, I was ready on an classbforum regarding greasing the sealed front wheel bearings. Has any one on here done it?? Below are the link. http://www.classbforum.com/forums/f8/greasing-chevy-sealed-wheel-bearings-2305.html

@bspurloc I don’t have electric fan I have the normal fan clutch. Two years ago I replace the fan clutch at that time it was a pain but I put anti seas on the thread.

@bspurloc I don’t have electric fan I have the normal fan clutch. Two years ago I replace the fan clutch at that time it was a pain but I put anti seas on the thread.

@BrownHP800 I have replace my 1st design for the 2nd design on my 2002 TB check my post. https://gmtnation.com/forums/threads/replacing-crankshaft-front-seal-solved.17742/

3 weeks ago I did this job and now I can report to you all. And no leaks With a 1 1/2" pipe 1 meter long the old bolt does not look as tough as is seem to be. Here you can see both tools in place. Old Harmonic Balancer removed Now lets see the different between the 1st and 2nd design 1st...

That is my idea @Mooseman tu use smaller size bolt to do the job

Ok will order the tools