Recent content by h82loseejr

Ok so what 4l60E transmissions swap into a 2004 envoy. Junkyard says only 04 which I know is crap. I dont care about changing bellhousing or some sensors. Junk yards will tell you a lot of stuff doesn't swap which I have swapped with much success. Thing is I had both engines already when I...

I do not even know what that is. I hate posts like this. People say that they are trying something and never tell how it works out. I have had succes "necroposting" or whatever your calling it in other sites with other problems. Funny though I use the search function to try to find what I want...

Does anyone have an idea of what other transmissions will go into the Envoy with say a bellhousing swap or possibly other small things. When calling junk yard they say 2004 only which I find really hard to believe.

Did you ever get this to work?

Hey Mooseman. I lost my copy of TIS2000 like the install disk....I have tried to find a place to download and i still have not found one. The link to yours is coming back "File not found"

i swapped my engine also...got it out in about 12 or so hours and was in the garage about 11pm getting everything swapped to have new engine ready to drop in in the morning...was taking disconnect off and came in twice to double check forums that i was removing it correctly...had a chisel behind...

i just installed my heated leather seats in my 03. My drivers seat was power from factory and passenger was manual...the power movement was plug and play for both sides. Gong to try to get the Heat working tomorrow on the passenger side. My donor did not have the driver door module so am...

so can i just update the bcm and and door modules? i do not want to do the pcm as i already licensed it with my hp tuner the only thing i was wondering about was the memory function of the seats i guess...i can live without them as i read where you can make the heated portion work without too...

yeah i got a kit and am doing all of them...most were shot anyway got all races out...my friend is going to use an old race and weld a plate on it and hole in the center so i can get the inside pinion race in...tried heating housing and freezing race only go it about half way in....i think i am...

I bought a parts Rig for its 3.73 axles. I am starrting to dismantle it and the Drivers side axle shaft wehre it goes into the carrier has what i would consider an excessive amount of up and down movement. How much is acceptable for the axle to move upward and down if i grab it and try moving...

Got this quote today for new bearings for the front diff...Just the carrier side. I had planned on replacing them before i install my axles out of my parts truck. Figured as much work as carrier is to get in and out that id throw the bearings in it because mine failed which promted my buying a...

Is it possible to add RPO codes to the BCM? I have a tech2 which is a clone from china. Does it have to be hooked up to the techline to do something like this? I bought a parts rig this weekend i needed a lot of parts and also at least 3.73 gearing...this one had the 3.73 along with g80 and...

@@@@@@@@@@UPDATE@@@@@@@@@@ Since i hate reading through threads only to see the person may or may not have resolved their issue but never type back to let others know what the solution was....in the end it was the engine...the first time it overheated it must have cracked the head or headgasket...

i just put water inbecause i was between pays and i still had to install the temp switch for the efans and didnt want to waste the coolant...but i do have a question how much flow should i be getting through the top hose as it does not seem like a lot is coming out of the motor

thanks for the ideas man i honestly am hoping this will clear it up and that maybe it is blocked passages as you were saying i have too much money into this thing already and cannot afford to put much more into it